Copper Desoldering Wick Solder Removal Braid

Reliable desoldering for precise electronic rework

This copper desoldering mesh braid (solder wick) is designed for clean, controlled removal of solder from circuit boards and electronic assemblies. Manufactured from finely woven copper wire, it offers excellent thermal conductivity and consistent capillary action to draw molten solder away from pads, leads and tracks.

The braid is pre-treated for effective wetting and works within a typical soldering range of 280-480 °C, making it suitable for common tin/lead and lead-free solder alloys. When used with flux (liquid or paste), it quickly absorbs molten solder, helping to clean pads without lifting traces or overheating nearby components. Its thin, flexible profile allows access to densely populated PCBs and fine-pitch components.

Why It's a Smart Choice

• Clean solder removal - Woven copper mesh efficiently wicks away molten solder, leaving pads ready for rework or component replacement.
• Controlled, low-risk desoldering - Provides localized heat transfer and solder absorption, reducing the risk of damaging pads, vias or sensitive components.
• Versatile for repair and rework - Ideal for removing excess solder, fixing bridges, cleaning pads, and servicing through-hole or SMD components on a wide range of electronic devices.

FAQ

Q: Do I need additional flux with this desoldering wick?
A: Yes, for best performance apply a small amount of flux to the braid or joint. This improves solder flow into the mesh and helps prevent oxidation.

Q: What temperature should I use on my soldering iron?
A: A working range of about 280-350 °C suits most tin/lead solders. For lead-free solder, 320-380 °C is common. Always start at the lower end and increase only if wicking is slow.

Q: Can this wick be used on SMD components?
A: Yes. The flexible braid is well suited to SMD pads and fine-pitch ICs. Use a narrow width for small pads and work carefully to avoid excessive heat.

Q: Is the copper braid reusable?
A: Only the unused section is reusable. Once a portion is saturated with solder, cut it off and continue with fresh braid.